Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SYSTEM › 2013.08–2014.03
RM30M0E _59 Vehicle Exterior _017121 WINDOW / GLASS _0086992 WINDOW DEFOGGER SYSTEM J

WINDOW / GLASS  WINDOW DEFOGGER SYSTEM  Rear Window Defogger System does not Operate  


DESCRIPTION

When the rear window defogger switch on the air conditioning control assembly is pressed, the operation signal is transmitted to the air conditioning amplifier assembly via LIN communication. When the air conditioning amplifier assembly receives the signal, it turns on the defogger relay to operate the window defogger system.

WIRING DIAGRAM

B351769E01
5.625,0.219 5.938,0.417 0.313,0.198 10 false 21 5.865,0.323 6.177,0.521 0.313,0.198 10 false B 5.698,0.677 6.01,0.875 0.313,0.198 10 false 4 5.865,0.865 6.313,1.063 0.448,0.198 10 false LIN1 5.635,1.156 5.948,1.354 0.313,0.198 10 false 14 5.865,1.26 6.313,1.458 0.448,0.198 10 false GND 5.698,2.427 6.01,2.625 0.313,0.198 10 false 1 5.865,2.531 6.177,2.729 0.313,0.198 10 false IG+ 5.865,3.063 6.344,3.26 0.479,0.198 10 false RDFG 5.635,2.958 5.948,3.156 0.313,0.198 10 false 38 2.438,0.458 2.885,0.656 0.448,0.198 10 false DOME 0.563,0.313 1.396,0.51 0.833,0.198 10 false from Battery 3.385,1.063 3.698,1.26 0.313,0.198 10 false IG+ 4.458,0.885 4.906,1.083 0.448,0.198 10 false LIN1 4.448,1.26 4.896,1.458 0.448,0.198 10 false GND 4.813,0.688 5.125,0.885 0.313,0.198 10 false 2 4.813,1.146 5.125,1.344 0.313,0.198 10 false 5 3.208,0.958 3.521,1.156 0.313,0.198 10 false 8 1.708,1.198 2.635,1.406 0.927,0.208 10 false ECU-IG NO. 1 0.396,1.063 1.333,1.99 0.938,0.927 10 false from Ignition or Starter Switch Assembly*1 or No. 1 Ignition Relay*2 0.083,2.667 2.479,2.875 2.396,0.208 10 false *1: w/o Smart Entry and Start System 0.083,3.042 2.479,3.25 2.396,0.208 10 false *2: w/ Smart Entry and Start System 3.344,1.51 3.792,1.708 0.448,0.198 10 false F4 3.344,1.677 4.854,2.052 1.51,0.375 10 false Air Conditioning Control Assembly 0.552,3.479 1.385,3.677 0.833,0.198 10 false from Battery 2.5,3.625 2.948,3.823 0.448,0.198 10 false DEF 3.49,2.969 3.802,3.167 0.313,0.198 10 false 1 4.229,2.979 4.542,3.177 0.313,0.198 10 false 2 4.229,3.385 4.542,3.583 0.313,0.198 10 false 3 3.49,3.385 3.802,3.583 0.313,0.198 10 false 5 3.458,3.844 3.906,4.042 0.448,0.198 10 false F75 3.438,3.99 4.448,4.198 1.01,0.208 10 false Defogger Relay 2.604,4.344 2.917,4.542 0.313,0.198 10 false 1 3.979,4.344 4.292,4.542 0.313,0.198 10 false 1 3.906,4.531 4.354,4.729 0.448,0.198 10 false F60 2.563,4.531 3.01,4.729 0.448,0.198 10 false M1 2.542,4.833 4.198,5.198 1.656,0.365 10 false Back Window Glass (Rear Window Defogger Wire) 0.688,5.375 2.469,5.583 1.781,0.208 10 false : LIN Communication Line 5.552,4.813 6,5.01 0.448,0.198 10 false F3 5.552,4.969 7.125,5.323 1.573,0.354 10 false Air Conditioning Amplifier Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK AIR CONDITIONING SYSTEM
a.

Check the air conditioning system.

HINT:

Both the window defogger system operation signal and air conditioning system operation signal are transmitted to the air conditioning amplifier assembly via the same communication line.


OK:

The air conditioning system operates normally.



Result:
Proceed to
OK
NG



OK

2.PERFORM ACTIVE TEST USING GTS

NG

2.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Active Test.


e.

According to the display on the GTS, perform the Active Test.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Defogger Relay (Rear) Defogger relay OFF, ON -
Body Electrical > Air Conditioner > Active Test
Tester Display
Defogger Relay (Rear)
50004 121 22
OK:

The window defogger system operates normally.



Result:
Proceed to
OK
NG



OK

3.REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

4.INSPECT DEFOGGER RELAY
3.REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY
a.

Replace the air conditioning amplifier assembly.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER>REMOVAL


b.

Check that the window defogger system operates normally.

OK:

The window defogger system operates normally.



Result:
Proceed to
OK
NG



OK

END (AIR CONDITIONING AMPLIFIER ASSEMBLY WAS DEFECTIVE)

NG

4.INSPECT DEFOGGER RELAY
a.

Remove the defogger relay.


b.

Inspect the defogger relay.

Click hereVehicle Exterior>WINDOW / GLASS>RELAY>INSPECTION


Result:
Proceed to
OK
NG



OK

5.CHECK HARNESS AND CONNECTOR (DEFOGGER RELAY - POWER SOURCE)

NG

REPLACE DEFOGGER RELAY

5.CHECK HARNESS AND CONNECTOR (DEFOGGER RELAY - POWER SOURCE)
a.
E281480C01
1.563,0.135 1.969,0.354 0.406,0.219 1.656,0.146 1.938,0.323 0.281,0.177 10 false F75 0.115,0.083 0.396,0.26 0.281,0.177 10 false *1
*1 Defogger Relay Holder


Remove the defogger relay.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F75-1 - Body ground Ignition switch ON 11 to 14 V
F75-5 - Body ground Always 11 to 14 V



Result:
Proceed to
OK
NG



OK

6.CHECK HARNESS AND CONNECTOR (DEFOGGER RELAY - AIR CONDITIONING AMPLIFIER ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.CHECK HARNESS AND CONNECTOR (DEFOGGER RELAY - AIR CONDITIONING AMPLIFIER ASSEMBLY)
a.

Remove the defogger relay.


b.

Disconnect the F3 air conditioning amplifier assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F75-2 - F3-38 (RDFG) Always Below 1 Ω
F75-2 or F3-38 (RDFG) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

7.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

7.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
a.
E182281C13
1.104,0.156 1.594,0.448 0.49,0.292 0.74,1.125 0.542,1.771 true 1.073,1.031 1.615,1.792 true 1.24,0.229 1.677,0.5 0.438,0.271 10 false F3 1.49,1.802 1.938,2.042 0.448,0.24 10 false GND 0.354,1.792 0.917,2.01 0.563,0.219 10 false RDFG 0.115,0.052 0.76,0.354 0.646,0.302 10 false *a
*a Component with harness connected
(Air Conditioning Amplifier Assembly)


Reconnect the air conditioning amplifier assembly connector.


b.

Reinstall the defogger relay.


c.

Remove the air conditioning amplifier assembly with its connectors still connected.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER>REMOVAL


d.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F3-38 (RDFG) - F3-14 (GND) Ignition switch ON, rear window defogger switch on Below 1 V
F3-38 (RDFG) - F3-14 (GND) Ignition switch ON, rear window defogger switch off 11 to 14 V



Result:
Proceed to
OK
NG



OK

8.CHECK HARNESS AND CONNECTOR (BACK WINDOW GLASS - DEFOGGER RELAY AND BODY GROUND)

NG

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

8.CHECK HARNESS AND CONNECTOR (BACK WINDOW GLASS - DEFOGGER RELAY AND BODY GROUND)
a.

Disconnect the F60 and M1 back window glass connectors.


b.

Remove the F75 defogger relay.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F60-1 - F75-3 Always Below 1 Ω
M1-1 - Body ground Always Below 1 Ω
F60-1 or F75-3 - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE BACK WINDOW GLASS

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR