Use the same procedure for both the RH side and LH sides.
The procedure described below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
67492A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
69260
4.REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
74232
5.REMOVE FRONT ARMREST BASE UPPER PANEL (w/o Power Window)
74232
6.REMOVE FRONT ARMREST BASE UPPER PANEL (w/ Power Window)
67602
7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
68172A
8.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP
67832
9.REMOVE FRONT DOOR SERVICE HOLE COVER
68102
10.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
68151D
11.REMOVE FRONT DOOR GLASS RUN
67404F
12.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY
69217F
13.REMOVE FRONT DOOR OUTSIDE HANDLE COVER (w/ Lock Cylinder)
69320
14.REMOVE FRONT DOOR LOCK ASSEMBLY
w/ Power Door Lock:
Disconnect the connector.
Using a T30 "TORX" socket wrench, remove the 3 screws.
Slide the front door lock assembly downward, and remove the front door lock assembly and cables as a unit.
When reusing the front door lock assembly:
Remove the door lock wiring harness seal from the front door lock assembly.
69760C
15.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY
Disengage the 5 claws and open the cover in the direction indicated by the arrow as shown in the illustration.
Disengage the guide and remove the front door inside locking cable assembly from the front door lock assembly.
69720B
16.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
Disengage the guide and remove the front door lock remote control cable assembly from the front door lock assembly.