Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE COMPARTMENT DOOR › 2013.08–2017.10
RM30M0E _59 Vehicle Exterior _017122 DOOR / HATCH _0087458 LUGGAGE COMPARTMENT DOOR N

DOOR / HATCH  LUGGAGE COMPARTMENT DOOR  ADJUSTMENT  


CAUTION / NOTICE / HINT

B345220C01
0.823,0.115 1.135,0.313 0.313,0.198 10 false *a 2.49,0.115 2.802,0.313 0.313,0.198 10 false *b
*a Centering Bolt
*b Standard Bolt


HINT:
·

Centering bolts are used to mount the door hinge to the door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

·

Specified torque for standard bolts is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 64401 1.INSPECT LUGGAGE COMPARTMENT DOOR PANEL SUB-ASSEMBLY

a.

Check that the clearance measurements are within the standard ranges.

B343241E01
0.365,1.031 0.583,1.292 0.219,0.26 10 false A 1.688,1.052 1.906,1.313 0.219,0.26 10 false B 3.396,0.906 3.615,1.167 0.219,0.26 10 false C 5.146,1.375 5.365,1.635 0.219,0.26 10 false D 6.615,1.281 6.833,1.542 0.219,0.26 10 false E 6.479,3.635 6.698,3.896 0.219,0.26 10 false F

Standard Clearance:
Area Measurement Area Measurement
A 8.0 mm (0.315 in.) B 11.9 mm (0.469 in.)
C 2.8 to 5.8 mm (0.111 to 0.228 in.) D 6.4 to 10.4 mm (0.252 to 0.409 in.)
E 5.1 to 9.1 mm (0.201 to 0.358 in.) F 3.7 to 7.7 mm (0.146 to 0.303 in.)



Hide 64401 5.ADJUST LUGGAGE COMPARTMENT DOOR PANEL SUB-ASSEMBLY

a.
B343242

Adjust the door position.

i.

Horizontally and vertically adjust the door by loosening the 4 luggage compartment door side hinge bolts.


ii.

Tighten the 4 luggage compartment door side hinge bolts after the adjustment.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)



b.
B343243

Adjust the striker position.

i.

Using a T40 "TORX" socket wrench, slightly loosen the 2 striker mounting screws.


ii.

Using a plastic-faced hammer, hit the striker to adjust its position.


iii.

Using a T40 "TORX" socket wrench, tighten the 2 striker mounting screws after the adjustment.

Torque:
23 N*m (235 kgf*cm, 17 ft.*lbf)