Home › Audio / Visual / Telematics › AUDIO / VIDEO › FRONT DOOR SPEAKER › 2013.08–2017.10
RM30M0E _56 Audio / Visual / Telematics _017106 AUDIO / VIDEO _0089068 FRONT DOOR SPEAKER A

AUDIO / VIDEO  FRONT DOOR SPEAKER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


PROCEDURE

Hide 1.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 69260 2.REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

Hide 74232 3.REMOVE FRONT ARMREST BASE UPPER PANEL (w/ Power Window)

Hide 74232 4.REMOVE FRONT ARMREST BASE UPPER PANEL (w/o Power Window)

Hide 5.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 86160 6.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

a.
E275693

Disconnect the connector.


b.

Using a drill bit with a diameter of less than 5 mm (0.197 in.), remove the 3 rivet heads as shown in the illustration.

NOTICE:
·

Do not touch the cone part of the front No. 1 speaker assembly.


·

Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.


·

Be careful as the cut rivet will be very hot.




c.

Continue drilling and push out the remaining rivet fragments.


d.

Disengage the 2 claws and remove the front No. 1 speaker assembly.


e.

Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.