Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER(for Sedan) › 2013.08–2017.10
RM30M0E _56 Audio / Visual / Telematics _017106 AUDIO / VIDEO _0089075 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  REMOVAL  


PROCEDURE

Hide 73370 1.REMOVE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH

Hide 86011R 2.REMOVE RADIO SETTING CONDENSER

NOTICE:

When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


a.
E271655

Remove the bolt.


b.

Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.


c.
E221953

Using a screwdriver, disengage the 3 claws and remove the terminal cover with wire harness from the condenser.


d.
E281111

Using a screwdriver, bend back and break off the claw as shown in the illustration.


e.

Remove the terminal cover from the wire harness.

NOTICE:
·

Make sure to hold the wire harness on the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

·

Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

·

Check for deformation of the terminal after the wire harness has been removed from the terminal cover.