The procedure described below is for the LH side. Use the same procedure for both the LH and RH sides, unless otherwise specified.
81570
1.REMOVE CENTER STOP LIGHT ASSEMBLY
2.REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type)
3.REMOVE REAR SEAT ASSEMBLY (for Separate Seat Type)
62332A
4.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
Disconnect the rear door opening trim weatherstrip LH to the extent that the rear seat side garnish LH and roof side inner garnish LH can be removed.
62331A
5.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
73370
6.DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH
73360
7.DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
62552F
8.REMOVE REAR SEAT SIDE GARNISH LH
62551F
9.REMOVE REAR SEAT SIDE GARNISH RH
Use the same procedure as for the LH side.
62472A
10.REMOVE ROOF SIDE INNER GARNISH LH
62471A
11.REMOVE ROOF SIDE INNER GARNISH RH
Use the same procedure as for the LH side.
64330D
12.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
64274
13.REMOVE NO. 1 ROOM PARTITION TRIM PAD (for Separate Seat Type)
64272B
14.REMOVE ROOM PARTITION BOARD LH (for Separate Seat Type)
73370
15.REMOVE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY
Remove the bolt.
Disengage the guide to remove the rear seat 3 point type outer belt assembly.
73143
16.REMOVE SEAT BELT HOLE SEAL
Disengage the 2 claws to remove the seat belt hole seal.