88625
1.INSTALL NO. 1 COOLER THERMISTOR
| *1 | No. 1 Cooler Evaporator Sub-assembly |
| *a | from Tank |
| *b | Fixed Part |
| *c | Sensor Part |
| *d | Next to Previous |
| *e | Plastic Case |
Install the No. 1 cooler thermistor as shown in the illustration.
| Mark | Measurement |
|---|---|
| a | 47.7 mm (1.88 in.) |
| b | 34.3 mm (1.35 in.) |
| c | 48 to 52 mm (1.89 to 2.05 in.) |
Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.
When reusing the evaporator, insert the thermistor one row next to the one that [was] used previously (*d in the illustration).
After inserting the thermistor, do not apply excessive force to the wire.
Directly insert the thermistor until the edge of the plastic case "*e" comes into contact with the evaporator "*1".
88501
2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
88515
3.INSTALL NO. 1 EXPANSION VALVE
87010
4.INSTALL AIR CONDITIONING UNIT ASSEMBLY