89221B
1.INSTALL BODY COMPUTER
Make sure that there is no foreign matter on the contact surfaces or connectors.
Make sure that there is no contamination by foreign matter.
Vertically align the 4 guides on the driver side junction block assembly side with those on the body computer side.
While following the guides, slide the body computer vertically in the direction indicated by the arrow to engage the 4 guides.
| *a | Push Area |
Press the push area of the body computer with the palm of one hand to engage the body computer lock and driver side junction block assembly lock.
When the 2 claws of the locks engage, check that a clicking sound can be heard.
Press the push area of the body computer with the palm of one hand.
Check that a clicking sound can be heard.
| *a | Driver Side Junction Block Assembly Enclosing Wall |
| *b | Body Computer Rear Surface |
Check that the body computer rear surface and driver side junction block assembly enclosing wall are at the same height.
| *a | Upper view of Body Computer |
| *b | Correct |
| *c | Incorrect |
When the lock is engaged correctly, the tip of the body computer lock and body computer lock engagement confirmation rib are in a straight line.
82730A
2.INSTALL DRIVER SIDE JUNCTION BLOCK ASSEMBLY
Connect the 8 connectors on the back side.
Install the driver side junction block assembly with the 2 bolts.
Connect the 8 connectors on the front side.
82817H
3.INSTALL WIRING HARNESS PROTECTOR
Engage the 2 clamps to install the wiring harness protector.
55301
4.INSTALL INSTRUMENT PANEL SUB-ASSEMBLY