Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB › 2013.08–2017.10
RM30M0E _52 Drivetrain _017093 AXLE AND DIFFERENTIAL _0090087 FRONT AXLE HUB A

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 53876A 2.REMOVE FRONT FENDER LINER (w/ ABS)

a.
C289767C01
0.667,2.469 1.083,2.052 true 1.427,1.698 1.74,1.854 0.313,0.156 10 false *a 0.49,2.406 0.802,2.604 0.313,0.198 10 false *1
*1 Pin Hold Clip
*a 90°


Using a screwdriver, turn the pin 90° and remove the pin hold clip.


b.

Remove the 7 clips, 3 screws, 4 grommets and front fender liner from the body.

C282318


Hide 3.SEPARATE FRONT SPEED SENSOR WIRE (w/ ABS)

a.
C282319

Disconnect the front speed sensor connector.


b.

Disengage the 2 clamps from the body.


c.
C282320

Disengage the 3 clamps.


d.

Remove the 2 bolts and separate the front speed sensor wire and front flexible hose from the body and front shock absorber assembly.


Hide 47313A 4.SEPARATE FRONT FLEXIBLE HOSE (w/o ABS)

Hide 6.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 43512 7.REMOVE FRONT DISC

Hide 43502C 8.REMOVE FRONT AXLE HUB SUB-ASSEMBLY

a.
C282325C01
2.771,1.125 3.021,0.802 3.021,0.802 2.906,1.427 true 3,0.646 3.313,0.802 0.313,0.156 10 false *a
*a Matchmark


Put matchmarks on the front drive shaft assembly and front axle hub sub-assembly.


b.

Using a plastic hammer, tap the end of the front drive shaft assembly and separate the fitting between the front drive shaft assembly and front axle hub sub-assembly.

NOTICE:

Be careful not to damage the thread portion of the front drive shaft assembly.


HINT:

If it is difficult to separate the front drive shaft assembly from the front axle hub sub-assembly, tap the end of the front drive shaft assembly using a brass bar and a hammer.



c.
C282326

Remove the 3 bolts, front axle hub sub-assembly and front disc brake dust cover from the steering knuckle.

NOTICE:
·

Do not place the front speed sensor side so that it is facing downward, and do not allow the front speed sensor side to become damaged or contact foreign matter (w/ ABS).

·

Do not drop the front axle hub sub-assembly.

·

Be careful not to damage the drive shaft boot.



HINT:

The front axle hub sub-assembly is a component of the front speed sensor (w/ ABS).