Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB(for Rear Drum Brake) › 2013.08–2017.10
RM30M0E _52 Drivetrain _017093 AXLE AND DIFFERENTIAL _0090092 REAR AXLE HUB(for Rear Drum Brake) A

AXLE AND DIFFERENTIAL  REAR AXLE HUB(for Rear Drum Brake)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 42403 2.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY

Hide 3.DISCONNECT SKID CONTROL SENSOR WIRE (w/ ABS)

a.
C282356

Using a screwdriver, disengage the claw of the connector lock portion and disconnect the skid control sensor wire connector.


Hide 42450B 4.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

a.
C290890

Remove the 4 bolts and rear axle hub and bearing assembly from the rear axle beam assembly.

NOTICE:
·

Do not place the rear speed sensor side so that it is facing downward, and do not allow the rear speed sensor side to become damaged or contact foreign matter (w/ ABS).

·

Do not drop the rear axle hub and bearing assembly.



HINT:

The rear axle hub and bearing assembly is a component of the rear speed sensor.