Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR SEAT ASSEMBLY (for Separate Seat Type)
2.REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type)
3.REMOVE REAR WHEEL
48540
4.REMOVE REAR SHOCK ABSORBER ASSEMBLY
| *a | Wooden Block |
| *b | Jack |
Support the rear axle beam assembly with a jack. Insert a wooden block between the jack and rear axle spring seat to prevent damage.
Keep supporting the rear axle beam assembly with a jack until the installation of the rear shock absorber assembly is complete.
| *a | Turn |
| *b | Hold |
While holding the rear shock absorber piston rod, remove the 2 nuts.
Remove the rear shock absorber cushion retainer and rear suspension support.
Remove the bolt and rear shock absorber assembly from the rear axle beam assembly.
48752A
5.REMOVE REAR SUSPENSION SUPPORT STOPPER
Remove the rear suspension support stopper from the rear shock absorber assembly.
48760B
6.REMOVE REAR SUSPENSION SUPPORT ASSEMBLY
Remove the rear suspension support assembly from the rear shock absorber assembly.