Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER(for Sedan)
RM30M0E _53 Suspension _017096 REAR SUSPENSION _0090103 REAR SHOCK ABSORBER(for Sedan) A

REAR SUSPENSION  REAR SHOCK ABSORBER(for Sedan)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 48760B 1.INSTALL REAR SUSPENSION SUPPORT ASSEMBLY

a.

Install the rear suspension support assembly to the rear shock absorber assembly.


Hide 48752A 2.INSTALL REAR SUSPENSION SUPPORT STOPPER

a.

Install the rear suspension support stopper to the rear shock absorber assembly.


Hide 48540 3.TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY

a.

Support the rear axle beam assembly with a jack. Insert a wooden block between the jack and rear axle spring seat to prevent damage.

NOTICE:

Keep supporting the rear axle beam assembly with a jack until the installation of the rear shock absorber assembly is complete.



b.
C288521C01
0.917,1.958 1.229,2.115 0.313,0.156 10 false *a 2.469,1.958 2.781,2.115 0.313,0.156 10 false *b
*a Correct
*b Incorrect


Install the rear suspension support and rear shock absorber cushion retainer.

NOTICE:

Make sure that the rear suspension support is correctly installed as shown in the illustration.



c.

Temporarily install the rear shock absorber assembly (lower side) to the rear axle beam assembly with the bolt.


d.
C288372C01
0.604,0.542 0.917,0.698 0.313,0.156 10 false *a
*a 15 to 18 mm (0.591 to 0.709 in.)


While holding the rear shock absorber piston rod, install a new nut (lower nut) to the specified standard.

Standard:

15 to 18 mm (0.591 to 0.709 in.)



e.

Install a new nut (upper nut) onto the lower nut.


f.
C287361C01
0.615,1.323 0.833,1.5 0.219,0.177 10 false *a 3.052,0.313 3.271,0.479 0.219,0.167 10 false *b
*a Hold
*b Turn


Hold the lower nut and tighten the upper nut against it.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


Hide 4.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 5. STABILIZE SUSPENSION

a.

Lower the vehicle.


b.

Bounce the vehicle up and down several times to stabilize the suspension.


Hide 48540 6.TIGHTEN REAR SHOCK ABSORBER ASSEMBLY

a.

Tighten the bolt of the rear shock absorber assembly (lower side).

Torque:
70 N*m (714 kgf*cm, 52 ft.*lbf)


Hide 7.INSTALL REAR SEAT ASSEMBLY (for Separate Seat Type)

Hide 8.INSTALL REAR SEAT ASSEMBLY (for Fixed Seat Type)