48231B
1.INSTALL REAR COIL SPRING LH
Support the spring seat of the rear axle beam assembly using an engine lifter and 2 wooden blocks.
Remove the 2 bolts and separate the rear axle beam assembly from the rear shock absorber assemblies LH and RH.
Slowly lower the rear axle beam assembly using engine lifter and 2 wooden blocks.
Install the rear lower coil spring insulator LH to the rear axle beam assembly.
| *a | 10 mm (0.394 in.) or less |
Install the rear upper coil spring insulator LH to the rear coil spring LH.
Install the rear upper coil spring insulator LH so that the distance between the stopper and the upper end of the rear coil spring LH is 10 mm (0.394 in.) or less.
| *a | Lower End of Rear Coil Spring |
| *b | Convex Portion |
| *c | Identification Mark |
Install the rear coil spring LH to the rear axle beam assembly.
Install the rear coil spring LH so that the distance between the lower end of the rear coil spring LH and spring stopper is within the range of the convex portion.
Install the rear coil spring so that the identification mark is positioned as shown in the illustration.
Slowly jack up the rear axle beam assembly using engine lifter and 2 wooden blocks, and temporarily tighten the rear axle beam assembly to the rear shock absorber assemblies LH and RH with the 2 bolts.
48231A
2.INSTALL REAR COIL SPRING RH
Use the same procedure described for the LH side.
58251D
3.INSTALL FRONT FLOOR PANEL BRACE LH
Install the front floor panel brace LH to the body with the 3 bolts.
58251D
4.INSTALL FRONT FLOOR PANEL BRACE RH
Use the same procedure described for the LH side.
46430
5.INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
Install the No. 3 parking brake cable assembly with the nut.
46420
6.INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY
Use the same procedure described for the No. 3 parking brake cable assembly.
47319F
7.INSTALL REAR FLEXIBLE HOSE LH
Install the rear No. 4 brake tube with the nut.
Install the rear flexible hose LH to the rear axle beam assembly with a new clip.
Make sure the clip is completely pushed in.
Using a 10 mm union nut wrench, install the rear No. 4 brake tube while holding the rear flexible hose LH with a wrench.
Do not kink or damage the brake line.
Do not allow any foreign matter, such as dirt or dust to enter the brake line.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
47318F
8.INSTALL REAR FLEXIBLE HOSE RH
Use the same procedure described for the LH side.
89516D
9.INSTALL SKID CONTROL SENSOR WIRE LH (w/ ABS)
Install the skid control sensor wire LH to the rear axle beam assembly with the nut.
Connect the skid control sensor wire connector.
89516C
10.INSTALL SKID CONTROL SENSOR WIRE RH (w/ ABS)
Use the same procedure described for the LH side.
11.BLEED BRAKE LINE
12.INSTALL REAR WHEELS
13. STABILIZE SUSPENSION
42110F
14.TIGHTEN REAR AXLE BEAM ASSEMBLY
Tighten the 2 bolts.
48540
15.FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH
48530
16.FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY RH
Use the same procedure described for the LH side.
17.INSPECT REAR WHEEL ALIGNMENT
18.CHECK FOR SPEED SENSOR SIGNAL (w/ ABS)