IGNITION SWITCH EXPRESSIONS
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
| Ignition Switch off | LOCK | Off (Lock) |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | On (Start) |
HANDLING PRECAUTION
When handling the electronic parts:
Do not subject parts such as ECUs and relays to shocks. Replace parts with new ones if they are dropped or subjected to a severe blow.
Do not expose any electronic parts to high temperatures or humidity.
Do not touch the connector terminals in order to prevent deformation or malfunctions due to static electricity.
When the power steering ECU assembly is replaced with a new one, perform torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
When handling the electric power steering column sub-assembly and power steering motor assembly:
Do not subject the electric power steering column sub-assembly, especially the motor and torque sensor, to shocks. Replace the electric power steering column sub-assembly with a new one if it is dropped or subjected to a severe blow.
Do not pull the wire harness.
Hold the motor and housing section when carrying the electric power steering column sub-assembly.
Do not hold the shaft or the tilt lever so as not to damage the electric power steering column sub-assembly.
When the electric power steering column sub-assembly or power steering motor assembly are replaced, perform the torque sensor zero point calibration after initializing the torque sensor zero point.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
When disconnecting and reconnecting the connectors:
When disconnecting the connectors related to the electronic power steering system, turn the ignition switch to ON, center the steering wheel, turn the ignition switch off, and then disconnect the connectors.
When reconnecting the connectors related to the electronic power steering system, make sure that the ignition switch is off. Center the steering wheel, and then turn the ignition switch to ON.
Do not turn the ignition switch to ON when the steering wheel is not centered.
Do not pull the wire harness.
If the above operations are not carried out properly, the steering center point (zero point) will deviate, which may lead to a difference in steering effort between turning right and turning left. If there is a difference in steering effort between turning right and turning left, perform torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION