Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2013.08–2017.10
RM30M0E _55 Steering _017103 POWER ASSIST SYSTEMS _0090108 POWER STEERING SYSTEM G

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. CHECK STEERING EFFORT (TORQUE)

NOTICE:

Some of these service operations may affect the SRS airbags. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


a.

Stop the vehicle on a level, paved road and align the wheels facing straight ahead.


b.

Disconnect the cable from the negative battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

d.

Connect the cable to the negative battery terminal.


e.

Using a torque wrench, check that the steering wheel set nut is properly tightened.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


f.

Start the engine so that the power steering is ready to operate.


g.

Turn the steering wheel 90 degrees to the right to check that the steering wheel turns smoothly. Check the opposite direction in the same manner.

OK:

Steering wheel turns smoothly



h.

Align the front wheels facing straight ahead.


i.

Disconnect the cable from the negative battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.




k.

Connect the cable to the negative battery terminal.


l.

Clear the DTCs.

Body Electrical > SRS Airbag > Trouble Codes
50001 188