The fail-safe function operates to stop the power assist when DTCs indicating ECU malfunctions are stored. However, when it is DTC C1533 or C1534 that has been stored, power assist continues.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Return-to-normal Condition | Note |
|---|---|---|---|---|---|
| C1531 | ECU Malfunction | An ECU internal malfunction (CPU malfunction). | Power steering ECU assembly | Ignition switch turned to ON again | Power Steering Warning Light comes on. |
| C1532 | ECU Malfunction | An ECU internal malfunction (peripheral circuit malfunction). | Power steering ECU assembly | Ignition switch turned to ON again | Power Steering Warning Light comes on. |
| C1533 | ECU Malfunction | An ECU internal malfunction (substrate temperature sensor malfunction). | Power steering ECU assembly | Ignition switch turned to ON again | Power Steering Warning Light comes on. |
| C1534 | ECU Malfunction | An ECU internal malfunction (EEPROM error). | Power steering ECU assembly | Ignition switch turned to ON again | Power Steering Warning Light may not illuminate. |
| C1535 | ECU Malfunction | An ECU internal malfunction (Steering wheel location data error). | Power steering ECU assembly | Ignition switch turned to ON again | Power Steering Warning Light may not illuminate. |
If the power steering ECU assembly, electric power steering column sub-assembly or power steering motor assembly have been replaced, perform torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
Clear the DTCs.
Check for DTCs.
DTCs C1531, C1532, C1533, C1534 and C1535 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG