Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2013.08–2017.10
RM30M0E _55 Steering _017103 POWER ASSIST SYSTEMS _0090108 POWER STEERING SYSTEM J

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  Power Steering Warning Light Circuit  


DESCRIPTION

If the power steering ECU assembly detects a malfunction, the power steering warning light comes on. At this time, the power steering ECU assembly stores a DTC in its memory.

When the power supply voltage to the power steering ECU assembly (terminal IG) drops, the required steering effort increases and the power steering warning light turns on.

WIRING DIAGRAM

C280662E01
0.521,1.729 0.833,1.906 0.313,0.177 10 false F38 0.823,0.875 1.292,1.094 0.469,0.219 10 false EMPS 4.917,0.75 5.125,0.948 0.208,0.198 10 false 10 5.198,0.896 5.458,1.104 0.26,0.208 10 false WL 1.375,0.76 1.51,0.948 0.135,0.188 10 false 7 0.531,1.896 1.75,2.302 1.219,0.406 10 false Combination Meter Assembly 5.208,2.906 5.563,3.115 0.354,0.208 10 false F12 5.208,3.094 7.146,3.396 1.938,0.302 10 false Power Steering ECU Assembly

CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly, electric power steering column sub-assembly or power steering motor assembly have been replaced, perform torque sensor zero point calibration.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION


HINT:

This flowchart is the inspection method for use when the power steering warning light remains on.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - POWER STEERING ECU ASSEMBLY)
a.

Disconnect the F12 power steering ECU assembly connector.


b.

Disconnect the F38 combination meter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F12-10 (WL) - F38-7 (EMPS) Always Below 1 Ω
F12-10 (WL) or F38-7 (EMPS) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.CHECK COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK COMBINATION METER ASSEMBLY
a.

Disconnect the F12 power steering ECU assembly connector.


b.

Turn the ignition switch to ON and check the condition of the power steering warning light illumination.

OK:

After turning the ignition switch to ON, the power steering warning light illuminates.



Result:
Proceed to
OK
NG



OK

REPLACE POWER STEERING ECU ASSEMBLY

NG

REPLACE COMBINATION METER ASSEMBLY