Home › Engine / Hybrid System › 1NZ-FE COOLING › THERMOSTAT › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017081 1NZ-FE COOLING _0090204 THERMOSTAT A

1NZ-FE COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 16331A 1.INSTALL THERMOSTAT

a.

Install a new gasket to the thermostat.


b.
A116188C03
1.698,1 2.552,0.813 true 1.281,0.24 1.594,0.417 0.313,0.177 10 true 10° 1.844,0.24 2.156,0.417 0.313,0.177 10 true 10° 2.594,0.729 2.76,0.896 0.167,0.167 10 false *a
*a Jiggle Valve


Install the thermostat to the cylinder block sub-assembly with the jiggle valve facing upward.

NOTICE:

The jiggle valve may be set within 10° of vertical in either direction, as shown in the illustration.



Hide 16321 2.CONNECT WATER INLET

a.

Connect the water inlet together with No. 2 radiator hose to the cylinder block sub-assembly with the 2 nuts.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)