27060
1.INSTALL GENERATOR WITH REGULATOR ASSEMBLY
Temporarily install the generator with regulator assembly to the cylinder block sub-assembly with the bolt.
16381
2.INSTALL FAN BELT ADJUSTING BAR
| *1 | Nut |
Temporarily install the fan belt adjusting bar to the generator with regulator assembly and oil pump assembly with the bolt and nut.
Move the generator with regulator assembly toward the cylinder block sub-assembly and fully tighten the nut.
82121
3.CONNECT ENGINE WIRE
Install the engine wire to the terminal B with the nut.
Engage the 2 clamps to connect the engine wire to the clamp and intake manifold.
Connect the generator with regulator assembly connector.
Install the terminal cap.
16361A
4.INSTALL FAN AND GENERATOR V BELT
16361A
5.ADJUST FAN AND GENERATOR V BELT
16361A
6.INSPECT FAN AND GENERATOR V BELT
11212
7.INSTALL NO. 2 CYLINDER HEAD COVER
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL