Home › Drivetrain › U340E AUTOMATIC TRANSMISSION / TRANSAXLE › SPEED SENSOR › 2013.08–2016.10
RM30M0E _52 Drivetrain _017087 U340E AUTOMATIC TRANSMISSION / TRANSAXLE _0090606 SPEED SENSOR A

U340E AUTOMATIC TRANSMISSION / TRANSAXLE  SPEED SENSOR  INSTALLATION  


PROCEDURE

Hide 89413B 1.INSTALL TRANSMISSION REVOLUTION SENSOR

a.

Apply a light coat of Toyota Genuine ATF WS to a new O-ring and install it to the transmission revolution sensor.

NOTICE:

Do not twist the O-ring.



b.

Install the transmission revolution sensor to the automatic transaxle assembly with the bolt.

Torque:
7.8 N*m (80 kgf*cm, 69 in.*lbf)

NOTICE:

Make sure that the O-ring is not damaged or does not jump out of position during installation.



c.

Connect the connector to the transmission revolution sensor.


Hide 74410 2.INSTALL BATTERY CARRIER ASSEMBLY

Hide 5.INSPECT FOR AUTOMATIC TRANSAXLE FLUID LEAK