41039A
1.INSTALL DIFFERENTIAL GEAR KIT
Coat the sliding and rotating surfaces of the differential gear kit (2 front differential pinions and 2 front differential side gears), 2 front differential side gear thrust washers and the 2 front differential pinion thrust washers with Toyota Genuine ATF WS.
Install the 2 front differential side gear thrust washers to the 2 front differential side gears.
Install the 2 front differential side gears, 2 front differential pinions and the 2 front differential pinion thrust washers to the front differential case.
Rotating each front differential side gear, install the 2 front differential pinions and the 2 front differential pinion thrust washers.
41342F
2.INSTALL FRONT NO. 1 DIFFERENTIAL PINION SHAFT
Coat the front No. 1 differential pinion shaft with Toyota Genuine ATF WS.
Install the front No. 1 differential pinion shaft to the front differential case so that the hole for the front differential pinion shaft straight pin is aligned with the hole in the front differential case.
3.INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH
41342A
4.INSTALL FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN
Using a 5 mm pin punch and a hammer, install the front differential pinion shaft straight pin to the front differential case.
Using a chisel and a hammer, stake the front differential case hole.
41221
5.INSTALL FRONT DIFFERENTIAL RING GEAR
| *a | 90 to 110°C (194 to 230°F) |
Using Toyota Genuine ATF WS and a heater, heat the front differential ring gear to 90 to 110°C (194 to 230°F).
Use thick gloves to protect your hands as the front differential ring gear is hot.
Do not heat the ring gear to more than 110°C (230°F).
Clean the contact surfaces of the front differential case and the front differential ring gear.
| *a | Matchmark |
Align the matchmarks on the front differential ring gear and the front differential case, and quickly install them.
Secure the front differential case in a vise between aluminum plates.
Do not overtighten the vise.
Install 4 new front differential ring gear set bolt lock plates and the 8 bolts.
Using SST and a hammer, stake the 4 front differential ring gear set bolt lock plates.
41311F
6.INSTALL FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING
Using SST and a press, install the front differential case rear tapered roller bearing inner race to the front differential case.
Using SST and a press, install the front differential case rear shim and the front differential case rear tapered roller bearing outer race to the transaxle case.
33481X
7.INSTALL SPEEDOMETER DRIVE GEAR
Install the speedometer drive gear to the front differential case.
41311E
8.INSTALL FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING
Using SST and a press, install the front differential case front tapered roller bearing inner race to the front differential case.
Using SST and a press, install the front differential case front tapered roller bearing outer race to the transaxle housing.