Home › Engine / Hybrid System › 1NZ-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL › 2013.08–2016.07
RM30M0E _51 Engine / Hybrid System _017073 1NZ-FE ENGINE MECHANICAL _0091004 REAR CRANKSHAFT OIL SEAL A

1NZ-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 1.REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)

Hide 30300 2.REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

Hide 31210 3.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)

Hide 31250B 4.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)

Hide 32101B 5.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)

a.
A166739E01
2.63,1.619 2.935,1.773 0.304,0.155 10 SST 1.954,2.054 2.592,1.726 false

Using SST, hold the crankshaft damper sub-assembly.

SST
09960-10010  (09962-01000, 09963-01000)


b.
A278687

Remove the 6 bolts, the rear drive plate spacer, the drive plate and ring gear sub-assembly, and the front drive plate spacer from the crankshaft.


Hide 13405 6.REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)

a.
A166739E01
2.63,1.619 2.935,1.773 0.304,0.155 10 SST 1.954,2.054 2.592,1.726 false

Using SST, hold the crankshaft damper sub-assembly.

SST
09960-10010  (09962-01000, 09963-01000)


b.
A249640

Remove the 6 bolts and flywheel sub-assembly from the crankshaft.


Hide 11401L 7.REMOVE REAR ENGINE OIL SEAL

A166928C01
2.927,0.677 2.177,1.156 true 2.969,0.563 3.281,0.719 0.313,0.156 10 false *a 1.021,0.594 1.333,0.75 0.313,0.156 10 false *b
*a Protective Tape
*b Cut Position


a.

Using a knife, cut off the lip of the rear engine oil seal.


b.

Using a screwdriver with its tip wrapped in protective tape, pry out the rear engine oil seal from the cylinder block sub-assembly and oil pan sub-assembly.

NOTICE:

After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.