Home › Engine / Hybrid System › 2NZ-FE ENGINE MECHANICAL › ENGINE UNIT › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017074 2NZ-FE ENGINE MECHANICAL _0091019 ENGINE UNIT A

2NZ-FE ENGINE MECHANICAL  ENGINE UNIT  REMOVAL  


PROCEDURE

Hide 16381 1.REMOVE FAN BELT ADJUSTING BAR

Hide 27060 2.REMOVE GENERATOR WITH REGULATOR ASSEMBLY

Hide 16268 4.REMOVE NO. 1 WATER BY-PASS PIPE

a.
A130350

Remove the 2 bolts, 2 nuts and No. 1 water by-pass pipe from the cylinder head sub-assembly and cylinder block sub-assembly.


b.

Remove the water by-pass pipe gasket from the cylinder block sub-assembly.


Hide 83530 5.REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY

Hide 89422 6.REMOVE ENGINE COOLANT TEMPERATURE SENSOR

Hide 44763 7.REMOVE BOOSTER VACUUM TUBE

a.
A130351

Remove the 2 bolts and booster vacuum tube from the cylinder head sub-assembly.


Hide 8.REMOVE WIRE HARNESS CLAMP BRACKET

a.
A130352

Remove the 2 bolts and 2 wire harness clamp brackets from the cylinder head sub-assembly.