Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › KNOCK SENSOR › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017072 2NZ-FE ENGINE CONTROL _0091227 KNOCK SENSOR A

2NZ-FE ENGINE CONTROL  KNOCK SENSOR  REMOVAL  


PROCEDURE

Hide 89615 2.REMOVE KNOCK SENSOR

a.
A171173

Disconnect the knock sensor connector.


b.

Remove the nut and knock sensor from the cylinder block sub-assembly.

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the knock sensor.