Home › Drivetrain › CLUTCH › CLUTCH SYSTEM(for C54)
RM30M0E _52 Drivetrain _017089 CLUTCH _0091136 CLUTCH SYSTEM(for C54) N

CLUTCH  CLUTCH SYSTEM(for C54)  BLEEDING  


CAUTION / NOTICE / HINT

NOTICE:

Wash off clutch fluid immediately if it comes in contact with any painted surface.


HINT:
·

If any work is performed on the clutch system or if air in the clutch lines is suspected, bleed air from the clutch hydraulic system.

·

In case of clutch fluid replacement, make sure that the old fluid is replaced in the clutch line between the reservoir and bleeder before bleeding.



PROCEDURE

Hide 1.FILL RESERVOIR WITH BRAKE FLUID

Hide 2.BLEED CLUTCH LINE

HINT:

In case of clutch fluid replacement, make sure that the old fluid is replaced in the clutch line between the reservoir and bleeder before bleeding.


a.
C292231

Remove the release cylinder bleeder plug cap from the release cylinder bleeder plug.


b.

Connect a vinyl tube to the release cylinder bleeder plug.


c.

Depress the clutch pedal 5 times, and then loosen the release cylinder bleeder plug while the pedal is depressed.


d.

When fluid no longer comes out, tighten the release cylinder bleeder plug, and then release the clutch pedal.


e.

Repeat both of the previous 2 steps 6 times.

NOTICE:

Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while replacing the brake fluid.



f.

Tighten the release cylinder bleeder plug.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)


g.

Depress the clutch pedal 10 times or more and confirm its operation.

NOTICE:

This must be performed before the engine is started.



h.

Install the release cylinder bleeder plug cap to the release cylinder bleeder plug.


i.

Check that all the air has been bled from the clutch line.


Hide 3.INSPECT BRAKE FLUID LEVEL IN RESERVOIR