Home › Drivetrain › CLUTCH › CLUTCH RELEASE CYLINDER
RM30M0E _52 Drivetrain _017089 CLUTCH _0091139 CLUTCH RELEASE CYLINDER A

CLUTCH  CLUTCH RELEASE CYLINDER  INSTALLATION  


PROCEDURE

Hide 31470 1.INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY

a.
C286547C01
0,0 3.427,0 false
V100135

Release Hub Grease


Apply release hub grease to the contact surfaces of the clutch release fork sub-assembly and release cylinder push rod.

Grease:

Toyota Genuine Release Hub Grease or equivalent



b.

Install the clutch release cylinder assembly to the manual transaxle assembly with the 2 bolts.

Torque:
11.8 N*m (120 kgf*cm, 9 ft.*lbf)


Hide 31482 2.CONNECT CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE

a.

Using a 10 mm union nut wrench, connect the clutch release cylinder to flexible hose tube to the clutch release cylinder assembly.

Torque:
15.2 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



Hide 3.FILL RESERVOIR WITH BRAKE FLUID

Hide 5.INSPECT FOR BRAKE FLUID LEAK

Hide 6.INSPECT BRAKE FLUID LEVEL IN RESERVOIR