Home › Drivetrain › C50 MANUAL TRANSMISSION / TRANSAXLE › MANUAL TRANSAXLE OIL
RM30M0E _52 Drivetrain _017090 C50 MANUAL TRANSMISSION / TRANSAXLE _0091166 MANUAL TRANSAXLE OIL G

C50 MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE OIL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT MANUAL TRANSAXLE OIL

a.

Stop the vehicle in a level place.


b.

Remove the center engine under cover (w/ Metal Type Under Cover).

Click hereEngine / Hybrid System>1NZ-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for Manual Transaxle)>REMOVAL


c.

Remove the No. 1 engine under cover sub-assembly (w/ Metal Type Under Cover).

Click hereEngine / Hybrid System>1NZ-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for Manual Transaxle)>REMOVAL


d.
C261387

Remove the manual transmission filler plug and gasket from the manual transaxle assembly.


e.
C283106C01
0.719,1.313 1.031,1.469 0.313,0.156 10 false *a
*a 0 to 5 mm (0 to 0.197 in.)


Check that the oil level is between 0 and 5 mm (0.197 in.) from the bottom lip of the manual transmission filler plug opening.

NOTICE:
·

An excessively large or small amount of manual transaxle oil may cause problems.

·

After replacing the manual transaxle oil, drive the vehicle and check the oil level again.




f.

Check for oil leakage when the oil level is low.


g.

Install a new gasket and manual transmission filler plug to the manual transaxle assembly.

Torque:
39.2 N*m (400 kgf*cm, 29 ft.*lbf)


h.

Install the No. 1 engine under cover sub-assembly (w/ Metal Type Under Cover).

Click hereEngine / Hybrid System>1NZ-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for Manual Transaxle)>INSTALLATION


i.

Install the center engine under cover (w/ Metal Type Under Cover).

Click hereEngine / Hybrid System>1NZ-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for Manual Transaxle)>INSTALLATION