Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › IGNITION COIL AND SPARK PLUG › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017071 1NZ-FE ENGINE CONTROL _0091212 IGNITION COIL AND SPARK PLUG A

1NZ-FE ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  REMOVAL  


PROCEDURE

Hide 11212 1.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 19500D 2.REMOVE NO. 1 IGNITION COIL

a.
A171202

Disconnect the 4 No. 1 ignition coil connectors.


b.

Remove the 4 bolts and 4 No. 1 ignition coils from the cylinder head cover sub-assembly.

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the No. 1 ignition coil.



Hide 19100P 3.REMOVE SPARK PLUG

a.
A171170

Using a 16 mm spark plug wrench, remove the 4 spark plugs from the cylinder head sub-assembly.

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the spark plug.



Hide 4.REMOVE PLUG CAP

HINT:

If the plug cap has any damage, replace it with a new one.


a.

Remove the plug cap of the No. 1 ignition coil.

A320172C01
2.677,0.344 3.104,0.552 false 2.844,2.01 3.104,2.24 false 3.5,3.094 3.833,3.094 false 1.396,3.135 1.396,2.823 true 2.49,0.24 2.802,0.396 0.313,0.156 10 false *1 3.875,2.99 4.188,3.146 0.313,0.156 10 false *2 1.344,3.146 1.656,3.302 0.313,0.156 10 false *3 2.688,1.927 3,2.083 0.313,0.156 10 false *a
*1 No. 1 Ignition Coil *2 Plug Cap
*3 Spring - -
*a Plug Cap Fitting - -
V100135

Section A - -


NOTICE:
·

When removing the plug cap, make sure not to damage the plug cap fitting of the No. 1 ignition coil.

·

When removing the plug cap, do not deform the spring of the No. 1 ignition coil or allow it to fall out.

·

If the plug cap fitting has any damage, replace the No. 1 ignition coil with a new one.

·

If the spring is deformed or falls out, replace the No. 1 ignition coil with a new one. (The spring cannot be reassembled.)



HINT:

Spread section A of the plug cap and pull downwards to remove the plug cap.