Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017071 1NZ-FE ENGINE CONTROL _0091213 ENGINE COOLANT TEMPERATURE SENSOR A

1NZ-FE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89422 1.INSTALL ENGINE COOLANT TEMPERATURE SENSOR

a.

Install a new gasket to the engine coolant temperature sensor.


b.

Using a 19 mm deep socket wrench, install the engine coolant temperature sensor to the cylinder head sub-assembly.

Torque:
19.6 N*m (200 kgf*cm, 14 ft.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the engine coolant temperature sensor.



c.

Connect the engine coolant temperature sensor connector.