Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › KNOCK SENSOR › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017071 1NZ-FE ENGINE CONTROL _0091214 KNOCK SENSOR A

1NZ-FE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 89615 1.INSTALL KNOCK SENSOR

a.
A172936E08
1.583,1.698 1.823,1.854 0.24,0.156 10 true 30°

Install the knock sensor to the cylinder block sub-assembly with the nut as shown in the illustration.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace the knock sensor.


·

Make sure that the knock sensor is in the correct position.




b.

Connect the knock sensor connector.