Home › Engine / Hybrid System › 1NZ-FE INTAKE / EXHAUST › INTAKE MANIFOLD › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017079 1NZ-FE INTAKE / EXHAUST _0091231 INTAKE MANIFOLD A

1NZ-FE INTAKE / EXHAUST  INTAKE MANIFOLD  INSTALLATION  


PROCEDURE

Hide 17111 1.INSTALL INTAKE MANIFOLD

a.

Install a new intake manifold to head gasket to the intake manifold.


b.

Temporarily install the intake manifold to the cylinder head sub-assembly with the 3 bolts and 2 nuts.


c.
A171136E01
1.479,0.094 1.635,0.292 0.156,0.198 10 true 1 0.99,0.146 1.146,0.344 0.156,0.198 10 true 2 2.302,0.135 2.458,0.333 0.156,0.198 10 true 3 0.042,0.802 0.198,1 0.156,0.198 10 true 4 2.927,0.344 3.083,0.542 0.156,0.198 10 true 5

Tighten the 3 bolts and 2 nuts in the order shown in the illustration.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)


d.

Install the 2 wire harness clamp brackets to the intake manifold with the 2 bolts.

Torque:
11 N*m (112 kgf*cm, 8 ft.*lbf)


e.

Engage the clamp to connect the wire harness to the intake manifold.


f.

Engage the 2 clamps to connect the wire harness to the wire harness clamp bracket.


Hide 15301 2.INSTALL OIL LEVEL DIPSTICK SUB-ASSEMBLY

a.

Install the oil level dipstick sub-assembly to the oil level dipstick guide.


Hide 16553C 3.INSTALL HOSE CLAMP

a.

Engage the clamp to install the hose clamp to the intake manifold.


Hide 4.INSTALL STUD BOLT

a.

Using a "TORX" socket wrench E6, install the 3 stud bolts to the intake manifold.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


Hide 44774 5.CONNECT UNION TO CONNECTOR TUBE HOSE

a.

Connect the union to connector tube hose to the intake manifold with the hose clip.


Hide 12261 6.CONNECT VENTILATION HOSE

a.

Connect the ventilation hose to the intake manifold with the hose clip.


Hide 16264 7.CONNECT NO. 2 WATER BY-PASS HOSE

a.

Engage the clamp to connect the No. 2 water by-pass hose to the hose clamp.


Hide 22030 8.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY