Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017072 2NZ-FE ENGINE CONTROL _0091218 CAMSHAFT OIL CONTROL VALVE A

2NZ-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSTALLATION  


PROCEDURE

Hide 11101J 1.INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Apply a light coat of engine oil to a new O-ring and install it to the camshaft timing oil control valve assembly.

NOTICE:

Do not twist the O-ring.



b.

Install the camshaft timing oil control valve assembly to the cylinder head sub-assembly with the bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the camshaft timing oil control valve assembly.



c.

Connect the camshaft timing oil control valve assembly connector.


Hide 16381 2.INSTALL FAN BELT ADJUSTING BAR

Hide 16361A 3.INSTALL FAN AND GENERATOR V BELT

Hide 11212 5.INSTALL NO. 2 CYLINDER HEAD COVER

a.

Temporarily install the No. 2 cylinder head cover to the cylinder head cover sub-assembly and intake manifold with the 4 nuts.


b.
A111172E01
1.177,0.052 1.333,0.25 0.156,0.198 10 true A 1.594,0.208 1.75,0.406 0.156,0.198 10 true A 1.177,1.74 1.333,1.938 0.156,0.198 10 true B 0.271,1.125 0.427,1.323 0.156,0.198 10 true B

Tighten the 2 nuts A.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


c.

Tighten the 2 nuts B.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)