Home › Power Source / Network › 2NZ-FE BATTERY / CHARGING › GENERATOR › 2013.08–2016.10
RM30M0E _57 Power Source / Network _017108 2NZ-FE BATTERY / CHARGING _0092353 GENERATOR A

2NZ-FE BATTERY / CHARGING  GENERATOR  INSTALLATION  


PROCEDURE

Hide 27060 1.INSTALL GENERATOR WITH REGULATOR ASSEMBLY

a.

Temporarily install the generator with regulator assembly to the cylinder block sub-assembly with the bolt.


Hide 16381 2.INSTALL FAN BELT ADJUSTING BAR

a.
A310445C01
0.917,0.333 1.833,0.167 true 1.896,0.073 2.385,0.333 0.49,0.26 10 true *1
*1 Nut


Temporarily install the fan belt adjusting bar to the generator with regulator assembly and oil pump assembly with the bolt and nut.


b.

Move the generator with regulator assembly toward the cylinder block sub-assembly and fully tighten the nut.

Torque:
18.5 N*m (189 kgf*cm, 14 ft.*lbf)


Hide 82121 3.CONNECT ENGINE WIRE

a.

Install the engine wire to the terminal B with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


b.

Engage the 2 clamps to connect the engine wire to the clamp and intake manifold.


c.

Connect the generator with regulator assembly connector.


d.

Install the terminal cap.


Hide 16361A 4.INSTALL FAN AND GENERATOR V BELT

Hide 16361A 5.ADJUST FAN AND GENERATOR V BELT

Hide 16361A 6.INSPECT FAN AND GENERATOR V BELT

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)