Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › ECM › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017072 2NZ-FE ENGINE CONTROL _0091220 ECM A

2NZ-FE ENGINE CONTROL  ECM  INSTALLATION  


PROCEDURE

Hide 89661 1.INSTALL ECM (for Automatic Transaxle)

a.

Engage the 3 guides to install the ECM to the ECM bracket.


b.

Install the ECM with ECM bracket to the vehicle with the 2 nuts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the ECM.



c.

Engage the clamp to connect the wire harness to the ECM bracket.


d.

Connect the 4 ECM connectors.


Hide 89661 2.INSTALL ECM (for Manual Transaxle)

a.

Engage the 3 guides to install the ECM to the ECM bracket.


b.

Install the ECM with ECM bracket to the vehicle with the 2 nuts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the ECM.



c.

Engage the clamp to connect the wire harness to the ECM bracket.


d.

Connect the 3 ECM connectors.


Hide 55550 3.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY