Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › HEATED OXYGEN SENSOR(for Sensor 1) › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017072 2NZ-FE ENGINE CONTROL _0091228 HEATED OXYGEN SENSOR(for Sensor 1) A

2NZ-FE ENGINE CONTROL  HEATED OXYGEN SENSOR(for Sensor 1)  INSTALLATION  


PROCEDURE

Hide 89465 1.INSTALL HEATED OXYGEN SENSOR (for Sensor 1)

a.
A179640C01
0.708,0.583 1.156,1.458 true 0.427,2.969 0.74,3.125 0.313,0.156 10 false *a 1.542,2.958 1.854,3.115 0.313,0.156 10 false *b 0.385,0.5 0.844,0.698 0.458,0.198 10 false SST
*a Fulcrum Length 30 mm
*b Fulcrum Length 300 mm


Using SST, install the heated oxygen sensor to the exhaust manifold.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the heated oxygen sensor.


HINT:
·

This torque value is effective when SST is parallel to the torque wrench.

·

The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

·

The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.).

·

If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




Hide 17167 2.INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.

Install the No. 1 exhaust manifold heat insulator to the exhaust manifold with the 3 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 3.INSTALL WIRE HARNESS CLAMP BRACKET

a.

Install the wire harness clamp bracket to the cylinder head sub-assembly with the bolt.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


b.

Engage the clamp to connect the wire harness to the wire harness clamp bracket.


c.

Engage the 2 clamps to connect the heated oxygen sensor wire to the wire harness clamp bracket.


d.

Connect the heated oxygen sensor connector.


Hide 5.INSPECT FOR EXHAUST GAS LEAK