22030
1.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
16264
2.DISCONNECT NO. 2 WATER BY-PASS HOSE
Disengage the clamp to disconnect the No. 2 water by-pass hose from the hose clamp.
12261
3.DISCONNECT VENTILATION HOSE
Loosen the hose clip and disconnect the ventilation hose from the intake manifold.
44774
4.DISCONNECT UNION TO CONNECTOR TUBE HOSE
Loosen the hose clip and disconnect the union to connector tube hose from the intake manifold.
5.REMOVE STUD BOLT
Using a "TORX" socket wrench E6, remove the 3 stud bolts from the intake manifold.
16553C
6.REMOVE HOSE CLAMP
Disengage the clamp to remove the hose clamp from the intake manifold.
15301
7.REMOVE OIL LEVEL DIPSTICK SUB-ASSEMBLY
Remove the oil level dipstick sub-assembly from the oil level dipstick guide.
17111
8.REMOVE INTAKE MANIFOLD
Disengage the 2 clamps to disconnect the wire harness from the wire harness clamp bracket.
Disengage the clamp to disconnect the wire harness from the intake manifold.
Remove the 2 bolts and 2 wire harness clamp brackets from the intake manifold.
Remove the 2 nuts, 3 bolts and intake manifold from the cylinder head sub-assembly.
Remove the intake manifold to head gasket from the intake manifold.