Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR WINDOW FRAME MOULDING
RM30M0E _59 Vehicle Exterior _017128 EXTERIOR PANELS / TRIM _0092440 REAR DOOR WINDOW FRAME MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR WINDOW FRAME MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 75762A 1.INSTALL REAR DOOR WINDOW FRAME FRONT MOULDING

a.

Clean the attachment surface.

i.

Using an infrared light, heat the adhesive remaining on the vehicle body.

Heating Temperature
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)

CAUTION:

Do not burn yourself with the hot vehicle body or infrared light.


NOTICE:

Do not heat the vehicle body excessively.



ii.

Using a piece of cloth, rub the remaining adhesive off the vehicle body.

NOTICE:

Remove any tape remaining on the vehicle body.



iii.

Using a non-residue solvent, clean the attachment surface.



b.

Engage the 2 clips and install a new rear door window frame front moulding.

NOTICE:

Thoroughly press the rear door window frame front moulding to ensure that it adheres.


HINT:

Peel back the backing paper from the double-sided tape before installing the rear door window frame front moulding.



Hide 68230C 2.INSTALL REAR DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY