1.INSPECT AND ADJUST BRAKE PEDAL
Inspect the brake pedal height.
Turn back the carpet.
Measure the shortest distance between the brake pedal pad surface and floor panel.
| *a | Brake Pedal Height | - | - |
|
Measuring Plane | - | - |
116.9 to 126.9 mm (4.61 to 4.99 in.)
If the brake pedal height is incorrect, adjust the brake pedal height according to the procedure below.
Adjust the brake pedal height.
Turn back the carpet.
| *1 | Stop Light Switch Assembly |
| *2 | Push Rod |
| *3 | Clevis Lock Nut |
| *a | Brake Pedal Height from Floor Panel |
Remove the stop light switch assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>REMOVAL
Loosen the clevis lock nut.
Adjust the brake pedal height by turning the push rod.
116.9 to 126.9 mm (4.61 to 4.99 in.)
Tighten the clevis lock nut.
Install the stop light switch assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>INSTALLATION
2.INSPECT BRAKE PEDAL FREE PLAY
| *a | Brake Pedal Free Play |
Inspect the brake pedal free play.
Stop the engine and depress the brake pedal several times until there is no vacuum left in the booster.
Depress the pedal until a slight resistance is felt. Measure the distance as shown in the illustration.
1.0 to 6.0 mm (0.0394 to 0.236 in.)
If the brake pedal free play is not as specified, check the clearance of the stop light switch assembly.
3.INSPECT BRAKE PEDAL RESERVE DISTANCE
Inspect the brake pedal reserve distance.
Turn back the carpet.
Lock the wheels with chocks to secure the vehicle.
Release the parking brake.
With the engine running, depress the brake pedal and measure the brake pedal reserve distance as shown in the illustration.
| *a | Reserve Distance | - | - |
|
Measuring Plane | - | - |
More than 67 mm (2.64 in.)
More than 71 mm (2.80 in.)
If the distance is not as specified, troubleshoot the brake system.