84345
1.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
84340
2.INSTALL STOP LIGHT SWITCH ASSEMBLY
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL(for RHD)>ADJUSTMENT
Install the stop light switch assembly into the adjuster until it slightly touches the brake pedal.
When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
Turn the stop light switch assembly a quarter turn clockwise to install the stop light switch assembly.
or less
When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
Connect the connector.
Check the protrusion of the plunger.
| Area | Measurement |
|---|---|
| a | 0.5 to 2.6 mm (0.020 to 0.102 in.) |
If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary.
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL(for LHD)>ADJUSTMENT
Do not depress or support the brake pedal.
55432B
3.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (for LHD)
55432B
4.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (for RHD)
55606
5.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY