Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM30M0E _54 Brake _017100 BRAKE (FRONT) _0092766 FRONT BRAKE G

BRAKE (FRONT)  FRONT BRAKE  INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.INSPECT BRAKE CYLINDER AND PISTON

a.

Check the front disc brake cylinder bore and front disc brake piston for rust and scoring.

If necessary, replace the front disc brake cylinder and front disc brake piston.


Hide 2.INSPECT PAD LINING THICKNESS

a.
C116885

Using a ruler, measure the front disc brake pad lining thickness.

Minimum thickness:

1.0 mm (0.0394 in.)


Thickness of new part (Reference):

12.0 mm (0.472 in.)


If the front disc brake pad lining thickness is equal to or less than the minimum thickness, replace the front disc brake pads.

HINT:

Be sure to check front disc thickness when replacing the front disc brake pads with new ones.



Hide 3.INSPECT FRONT DISC BRAKE PAD SUPPORT PLATE

a.

Make sure that the front disc brake pad support plates have sufficient rebound, no deformation, cracks or wear, and that all rust and dirt are cleaned off.

If necessary, replace the front disc brake pad support plates.


Hide 4.INSPECT DISC THICKNESS

a.
C282654

Using a micrometer, measure the front disc thickness.

Minimum thickness:

19.0 mm (0.748 in.)


Thickness of new part (Reference):

22.0 mm (0.866 in.)


If the front disc thickness is less than the minimum, replace the front disc.


Hide 5.INSPECT DISC RUNOUT

a.

Inspect the front axle hub bearing looseness and front axle hub runout.

Click hereDrivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB>ON-VEHICLE INSPECTION


b.
C282653C01
2.042,1.177 2.583,1.063 2.583,1.063 2.073,1.229 true 2.625,0.969 2.938,1.125 0.313,0.156 10 false *a
*a Matchmark


Align the matchmarks on the front disc and front axle hub sub-assembly, and install the front disc.


c.
C285145E01
0.75,1.458 1.521,1.708 true 0.469,1.365 0.927,1.563 0.458,0.198 10 false SST

Using SST to hold the front disc, tighten the front disc with the 4 hub nuts.

SST
09330-00021  

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)


d.
C282655

Using a dial indicator, measure the disc runout 10 mm (0.394 in.) away from the outer edge of the front disc.

Maximum disc runout:

0.05 mm (0.00197 in.)


If the runout exceeds the maximum value, change the installation positions of the front disc and front axle hub sub-assembly to make the minimum runout. If the runout exceeds the maximum even when the installation positions are changed, grind the front disc. If the front disc thickness is less than the minimum, replace the front disc.

NOTICE:

Keep the magnet of the dial indicator away from the front axle hub sub-assembly.



e.

Remove the 4 hub nuts and the front disc.