Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB › 2013.08–2017.10
RM30M0E _52 Drivetrain _017093 AXLE AND DIFFERENTIAL _0090087 FRONT AXLE HUB G

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 47313A 2.SEPARATE FRONT FLEXIBLE HOSE (w/ ABS)

Hide 47313A 3.SEPARATE FRONT FLEXIBLE HOSE (w/o ABS)

Hide 4.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 43512 5.REMOVE FRONT DISC

Hide 6.INSPECT FRONT AXLE HUB BEARING LOOSENESS

a.
C282321

Using a dial indicator, check for looseness near the center of the front axle hub sub-assembly.

Maximum looseness:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the front speed sensor (w/ ABS).



If the looseness exceeds the maximum, replace the front axle hub sub-assembly.


Hide 7.INSPECT FRONT AXLE HUB RUNOUT

a.
C282322

Using a dial indicator, check for runout on the surface of the front axle hub sub-assembly outside the front axle hub bolts.

Maximum runout:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Make sure to set the tip of the dial indicator towards the outside of the front axle hub bolts.

·

Keep the magnet of the dial indicator away from the front speed sensor (w/ ABS).



If the runout exceeds the maximum, replace the front axle hub sub-assembly.


Hide 43512 8.INSTALL FRONT DISC

Hide 9.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 47313A 10.INSTALL FRONT FLEXIBLE HOSE (w/ ABS)

Hide 47313A 11.INSTALL FRONT FLEXIBLE HOSE (w/o ABS)

Hide 12.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)