Because the LH side front flexible hose and RH side front flexible hose are not interchangeable, verify the part number when installing the front flexible hoses.
If the front flexible hoses are to be reused, install them after checking the identification marks placed when each front flexible hose was removed.
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
47313A
1.INSTALL FRONT FLEXIBLE HOSE (w/ ABS)
| *a | Lock Hole |
Install the front flexible hose to the front disc brake cylinder assembly with a new union bolt and a new gasket.
Install the front flexible hose lock securely into the lock hole in the front disc brake cylinder assembly.
Install the front speed sensor wire and front flexible hose to the front shock absorber assembly with the bolt.
Install the front speed sensor wire and front flexible hose without twisting them.
Install the front speed sensor wire first and then the front flexible hose.
Install the front flexible hose to the body with a new clip.
When installing the front flexible hose, face the identification mark to the outside of the vehicle and minimize twisting of the front flexible hose.
Install the clip as far as it will go.
Using a 10 mm union nut wrench, connect the brake tube to the front flexible hose while holding the front flexible hose with a wrench.
Do not bend or damage the brake tube.
Do not allow any foreign matter such as dirt or dust to enter the brake tube from the connecting parts.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
47313A
2.INSTALL FRONT FLEXIBLE HOSE (w/o ABS)
| *a | Lock Hole |
Install the front flexible hose to the front disc brake cylinder assembly with a new union bolt and a new gasket.
Install the front flexible hose lock securely into the lock hole in the front disc brake cylinder assembly.
Install the front flexible hose to the front shock absorber assembly with the bolt.
Install the front flexible hose without twisting it.
Install the front flexible hose to the body with a new clip.
When installing the front flexible hose, face the identification mark to the outside of the vehicle and minimize twisting of the front flexible hose.
Install the clip as far as it will go.
Using a 10 mm union nut wrench, connect the brake tube to the front flexible hose while holding the front flexible hose with a wrench.
Do not bend or damage the brake tube.
Do not allow any foreign matter such as dirt or dust to enter the brake tube from the connecting parts.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
3.BLEED BRAKE LINE
for LHD
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID(for LHD)>BLEEDING
for RHD
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID(for RHD)>BLEEDING
4.INSTALL FRONT WHEEL