47316A
1.INSTALL REAR BRAKE TUBE FLEXIBLE HOSE (for Rear Disc Brake)
| *a | Lock Hole |
Install the rear brake tube flexible hose with a new union bolt and a new gasket.
Install the rear flexible hose lock securely into the lock hole in the rear disc brake cylinder assembly.
Install the rear brake tube flexible hose with a new clip.
Using a 10 mm union nut wrench, connect the brake tube while holding the rear brake tube flexible hose with a wrench.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
47319F
2.INSTALL REAR FLEXIBLE HOSE
Install the rear flexible hose with 2 new clips.
Install the clip as far as it will go.
Using a 10 mm union nut wrench, connect the 2 brake tubes to the rear flexible hose while holding the rear flexible hose with a wrench.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
3.BLEED BRAKE LINE
for LHD
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID(for LHD)>BLEEDING
for RHD
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID(for RHD)>BLEEDING
4.INSTALL REAR WHEEL