28800
1.REMOVE BATTERY
74431
2.REMOVE BATTERY TRAY
74410
3.REMOVE BATTERY CARRIER ASSEMBLY
58910C
4.REMOVE REAR CONSOLE BOX ASSEMBLY
57533B
5.REMOVE FRONT FLOOR CENTER BRACE
17410
6.REMOVE FRONT EXHAUST PIPE ASSEMBLY
58151
7.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
Remove the 2 bolts, nut and front No. 1 floor heat insulator from the body.
33820B
8.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
| *1 | Clip A |
| *2 | Clip B |
| *3 | Nut |
|
Rotate approximately 180° |
Remove the clip A and disconnect the select cable end of the transmission control cable assembly from the floor shift shift lever assembly.
Widen the clip B and disconnect the shift cable end of the transmission control cable assembly from the floor shift shift lever assembly.
Rotate the 2 nuts of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, separate the transmission control cable assembly from the floor shift shift lever assembly.
Do not rotate the nut excessively as it may damage the internal spring and the transmission control cable assembly will not be reusable.
Remove the 2 clips A and 2 washers, and disconnect the transmission control cable assembly from the floor shift selecting bellcrank assembly.
Remove the 2 clips B and separate the transmission control cable assembly from the control cable bracket.
Remove the 3 nuts and transmission control cable assembly from the body.
33829
9.REMOVE TRANSMISSION CONTROL CABLE SUPPORT
Perform this procedure only when replacement of the transmission control cable support is necessary.
Remove the nut and transmission control cable support from the body.