Home › Drivetrain › C54 MANUAL TRANSMISSION / TRANSAXLE › BACK-UP LIGHT SWITCH(for 2NZ-FE) › 2013.08–2016.10
RM30M0E _52 Drivetrain _017091 C54 MANUAL TRANSMISSION / TRANSAXLE _0094353 BACK-UP LIGHT SWITCH(for 2NZ-FE) A

C54 MANUAL TRANSMISSION / TRANSAXLE  BACK-UP LIGHT SWITCH(for 2NZ-FE)  REMOVAL  


PROCEDURE

Hide 74410 3.REMOVE BATTERY CARRIER ASSEMBLY

Hide 33820B 4.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.
C283114E01
2.052,1.594 2.208,1.792 0.156,0.198 10 true A 2.771,1.073 2.927,1.271 0.156,0.198 10 true B

Remove the clip A and washer, and disconnect the transmission control cable assembly from the floor shift selecting bellcrank assembly.


b.

Remove the clip B and separate the transmission control cable assembly from the control cable bracket.


Hide 84210 5.REMOVE BACK-UP LIGHT SWITCH ASSEMBLY

a.
C283168E01
1.094,0.313 2.031,0.792 true 0.792,0.229 1.25,0.427 0.458,0.198 10 false SST

Disconnect the connector from the back-up light switch assembly.


b.

Disengage the 2 clamps and separate the wire harness of the back-up light switch assembly from the manual transaxle assembly.


c.

Using SST, remove the back-up light switch assembly and gasket from the manual transaxle assembly.

SST
09817-16011