33829
1.INSTALL TRANSMISSION CONTROL CABLE SUPPORT
Perform this procedure only when replacement of the transmission control cable support is necessary.
| *a | Arrow Mark |
| *b | Detent |
Install the transmission control cable support to the body with the nut.
Install the transmission control cable support so that its arrow mark points to the front of the vehicle.
Make sure that the detent of the transmission control cable support is pushing against the dash silencer.
33820B
2.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
Install the transmission control cable assembly to the body with the 3 nuts.
| *a | Paint Mark |
Install the transmission control cable assembly to the control cable bracket with 2 new clips B.
Make sure that the paint marks on the transmission control cable assembly are aligned with the slits in the control cable bracket before installing the clips.
Connect the transmission control cable assembly to the floor shift selecting bellcrank assembly with the 2 washers and 2 clips A.
| *1 | Nut |
| *2 | Lock |
|
Rotate approximately 180° |
|
Push in |
Rotate the 2 nuts of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, push in the lock.
Do not rotate the nut excessively as it may damage the internal spring and the transmission control cable assembly will not be reusable.
| *1 | Clip A |
| *2 | Clip B |
| *3 | Lock |
| *a | Protrusion |
Install the transmission control cable assembly to the floor shift shift lever assembly.
Install the transmission control cable assembly with the protrusion of the cable outer facing upwards.
After installation, make sure that the lock is projecting from A as shown in the illustration.
Engage the clip B to connect the shift cable end of the transmission control cable assembly to the floor shift shift lever assembly.
Connect the select cable end of the transmission control cable assembly to the floor shift shift lever assembly with the clip A.
Install the transmission control cable assembly with the protrusion of the select cable end facing upwards.
Perform the installation with the clip A at the correct direction as shown in the illustration.
58151
3.INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR
Install the front No. 1 floor heat insulator to the body with the 2 bolts and nut.
17410
4.INSTALL FRONT EXHAUST PIPE ASSEMBLY
57533B
5.INSTALL FRONT FLOOR CENTER BRACE
58910C
6.INSTALL REAR CONSOLE BOX ASSEMBLY (w/ Console Box Lid)
58910C
7.INSTALL REAR CONSOLE BOX ASSEMBLY (w/o Console Box Lid)
74410
8.INSTALL BATTERY CARRIER ASSEMBLY
74431
9.INSTALL BATTERY TRAY
28800
10.INSTALL BATTERY
11.INSPECT FOR EXHAUST GAS LEAK