AIR CONDITIONING AMPLIFIER ASSEMBLY
Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.
| Terminal No.
(Symbol) |
Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F40-2 (AC1) - F40-11 (GND)*1 | L - W-B | Magnet clutch request signal | ·
Engine running ·
Blower switch: 1 ·
A/C switch: Off |
11 to 14 V |
·
Engine running ·
Blower switch: 1 ·
A/C switch: On (magnet clutch on) |
Below 1 V | |||
| F40-3 (PSW) - F40-11 (GND)*1 | P - W-B | Air conditioning pressure switch signal | ·
Engine running ·
Refrigerant pressure normal ·
Blower switch: 1 ·
A/C switch: On |
Below 1 V |
·
Engine running ·
Refrigerant pressure abnormal (less than 196 kPa [2.0 kgf/cm2, 28 psi] or more than 3140 kPa [32.0 kgf/cm2, 455.3 psi]) ·
Blower switch: 1 ·
A/C switch: On |
11 to 14 V | |||
| F40-5 (SG-2) - Body ground | GR - Body ground | Ground for evaporator temperature sensor | Always | Below 1 Ω |
| F40-6 (TE) - F40-5 (SG-2) | BR - GR | Evaporator temperature sensor signal | ·
Ignition switch ON ·
Evaporator temperature (ambient): 0°C (32°F) |
3.89 to 5.93 V |
·
Ignition switch ON ·
Evaporator temperature (ambient): 15°C (59°F) |
2.35 to 3.59 V | |||
·
Ignition switch ON ·
Evaporator temperature (ambient): 20°C (68°F) |
1.97 to 3.01 V | |||
·
Ignition switch ON ·
Evaporator temperature (ambient): 25°C (77°F) |
1.64 to 2.51 V | |||
·
Ignition switch ON ·
Evaporator temperature (ambient): 30°C (86°F) |
1.37 to 2.1 V | |||
| F40-7 (IG+) - F40-11 (GND) | G - W-B | Power source (IG) | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| F40-9 (A/C) - F40-11 (GND)*1 | G - W-B | A/C switch signal | ·
Engine running ·
Blower switch: 1 ·
A/C switch: Off |
11 to 14 V |
·
Engine running ·
Blower switch: 1 ·
A/C switch: On |
Below 1 V | |||
| F40-11 (GND) - Body ground | W-B - Body ground | Ground for main power supply | Always | Below 1 Ω |
*1: w/ Cooler System
ECM
for 1NZ-FE with Automatic Transaxle:
Click hereEngine / Hybrid System>1NZ-FE ENGINE CONTROL>SFI SYSTEM(for Automatic Transaxle)>TERMINALS OF ECM
for 1NZ-FE with Manual Transaxle:
Click hereEngine / Hybrid System>1NZ-FE ENGINE CONTROL>SFI SYSTEM(for Manual Transaxle)>TERMINALS OF ECM
for 1NZ-FE with Air Fuel Ratio Sensor:
Click hereEngine / Hybrid System>1NZ-FE ENGINE CONTROL>SFI SYSTEM(w/ Air Fuel Ratio Sensor)>TERMINALS OF ECM
for 2NZ-FE with Automatic Transaxle:
Click hereEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM(for Automatic Transaxle)>TERMINALS OF ECM
for 2NZ-FE with Manual Transaxle:
Click hereEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM(for Manual Transaxle)>TERMINALS OF ECM