Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER(for Hatchback) › 2014.03–2017.10
RM30M0E _56 Audio / Visual / Telematics _017106 AUDIO / VIDEO _0116470 NOISE FILTER(for Hatchback) A

AUDIO / VIDEO  NOISE FILTER(for Hatchback)  INSTALLATION  


PROCEDURE

Hide 86011R 1.INSTALL RADIO SETTING CONDENSER

a.
E283915

Engage the claw to install a new terminal cover to the wire harness.

NOTICE:
·

Make sure to hold the wire harness so that the crimping side of the terminal is facing up when installing the wire harness to the terminal cover.

·

Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

·

Do not use excessive force when inserting the wire harness into the terminal cover.

·

If the terminal cover has been deformed at installation, replace the terminal and terminal cover with new ones.




b.
E221975

Engage the 3 claws to install the terminal cover with wire harness and a new condenser.

NOTICE:
·

Do not use excessive force when inserting the terminal cover into the condenser.

·

If the terminal cover has been deformed at installation, replace the terminal, terminal cover and condenser with new ones.




c.

Engage the clamp to install the radio setting condenser with wire harness.


d.

Install the bolt.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


Hide 62572A 2.INSTALL ROOF SIDE INNER LOWER GARNISH LH