Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR(for Sensor 1) › 2014.03–2016.07
RM30M0E _51 Engine / Hybrid System _017071 1NZ-FE ENGINE CONTROL _0116488 AIR FUEL RATIO SENSOR(for Sensor 1) A

1NZ-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 1)  REMOVAL  


PROCEDURE

Hide 11212 1.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 2.REMOVE WIRE HARNESS CLAMP BRACKET

a.
A171209

Disconnect the air fuel ratio sensor connector.


b.

Disengage the 2 clamps to disconnect the air fuel ratio sensor wire from the wire harness clamp bracket.


c.
A171210

Disengage the clamp to disconnect the wire harness from the wire harness clamp bracket.


d.

Remove the bolt and wire harness clamp bracket from the cylinder head sub-assembly.


Hide 17167 3.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.
A171148

Remove the 4 bolts and No. 1 exhaust manifold heat insulator from the exhaust manifold.


Hide 89467B 4.REMOVE AIR FUEL RATIO SENSOR

a.
A319228C01
1.073,1.677 1.146,1.521 true 0.927,1.708 1.229,1.885 0.302,0.177 10 true SST

Using SST, remove the air fuel ratio sensor from the exhaust manifold.

SST
09224-00010  

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the air fuel ratio sensor.