Home › Engine / Hybrid System › 1NZ-FE INTAKE / EXHAUST › EXHAUST MANIFOLD › 2014.03–2016.07
RM30M0E _51 Engine / Hybrid System _017079 1NZ-FE INTAKE / EXHAUST _0091232 EXHAUST MANIFOLD A

1NZ-FE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


PROCEDURE

Hide 58910C 1.REMOVE REAR CONSOLE BOX ASSEMBLY (w/ Console Box Lid)

Hide 58910C 2.REMOVE REAR CONSOLE BOX ASSEMBLY (w/o Console Box Lid)

Hide 89465 3.REMOVE HEATED OXYGEN SENSOR (w/o Air Fuel Ratio Sensor)

Hide 89467B 4.REMOVE AIR FUEL RATIO SENSOR (w/ Air Fuel Ratio Sensor)

Hide 57533B 5.REMOVE FRONT FLOOR CENTER BRACE

A171156

a.

Remove the 4 bolts and front floor center brace from the vehicle.


Hide 17410 6.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.
A171154

Using a clip remover, remove the clip from the front floor carpet assembly.


b.

Disengage the front floor carpet assembly and peel it back.


c.
A171155

Disconnect the heated oxygen sensor connector.


d.

Remove the heated oxygen sensor wire grommet and pass the connector through the hole to the outside of the vehicle.


e.
A171150

Remove the 2 bolts and 2 compression springs to separate the front exhaust pipe assembly from the exhaust manifold.


f.

Remove the 2 bolts and 2 compression springs to separate the front exhaust pipe assembly from the tail exhaust pipe assembly.


g.

Disconnect the 3 exhaust pipe supports to remove the front exhaust pipe assembly from the vehicle.


h.

Remove the 2 exhaust pipe gaskets from the exhaust manifold and front exhaust pipe assembly.


Hide 25591 7.REMOVE MANIFOLD SUPPORT BRACKET

a.
A171147

Remove the 3 bolts and manifold support bracket from the exhaust manifold and cylinder block sub-assembly.


Hide 17141 8.REMOVE EXHAUST MANIFOLD

a.
A171146

Remove the 3 bolts, 2 nuts and exhaust manifold from the cylinder head sub-assembly.


b.

Remove the exhaust manifold to head gasket from the cylinder head sub-assembly.